Yamaha YXZ 1000 Rear Wing for Baja Designs 30" RTL Polaris RZR 200

Yamaha YXZ 1000 Rear Wing for Baja Designs 30" RTL Polaris RZR 200Our bolt on Yamaha YXZ 1000 Rear Wing is cut out to fit a 30" Baja Designs RTL Chase Light and is the easiest way to give your Cagewrx Roll Cage that custom look! This rear wing attaches to your existing Cagewrx roof and does not require any other hardware to mount. The Baja Designs RTL Chase Light will mount flush into the wing for a super clean look. The kit can be purchased with or without the Chase Light. A separate wiring harness can also be

Skid plate options available

This block is not needed for recreational use

X3 Magnus 3” Full Turbo Back Exhaust with Block Off Plate

Since clutching is a balance between the primary and secondary

No need to cut and replace a zip tie when you need to service a cable

Trinity Racing pullers are superior to any other puller on the market

46mm (Red) compressor with 42mm turbine for instantaneous spool time and insane top-end power

Simply Loosen The Pivot Bolt

Unlike bushings

Built for High Temps

We Recommend The Used Of A New Fuel Pump Seal

Although it is recommended to run power straight to the battery