Flexible Build Plate Kit for Sidewinder X2 CR10V2

Flexible Build Plate Kit for Sidewinder X2 CR10V2The flexible steel print surface is held in place by included sheet magnet. The surface is powder coated, textured PEI. The textured surface gives the bottom of your prints a nice textured look and helps hide imperfections. To use: Allow the print surface to cool, and remove and flex the sheet away from the print, the finished print will pop off. Works best on prints larger than 25x25mm. For smaller prints, flex the bed towards the print. *IMPORTANT*

Single Capture: 200 x 100mm

Precision Printing: With consistent diameter and minimal warping

engraving file format supports NC

• Also called the control board or motherboard

even when exposed to prolonged sunlight and outdoor environments

Silicone sock

FLEXIBLE AND PORTABLE

PolyCast™ features two unique technologies:

• Compatible with Ender-3

such as self-test

Cover Skeleton*2

drums and tubes and over-length plate engraving or cutting