Tin Knocker Roll Former, 24 Ga Pittsburgh with Stand Baileigh Ornamental Benders

Tin Knocker Roll Former, 24 Ga Pittsburgh with Stand Baileigh Ornamental BendersStand Included Normally in stock in one of our warehouses (CA, OH). On the job site or in the shop, this portable little rollformer is a work horse for 24 gauge and lighter material. It is available with power flanging attachment and is perfect for field use. With the included, all steel stand, it will also fit right in with your other shop equipment. Specifications: Capacity: 24 Gauge Mild Steel Motor: 1 2 HP, 1700 RPM, 115 Volt, Single Phase, 60 Hz

The BB-14418 will even handle 22gauge stainless steel sheet metal for those exotic jobs that come along

Dimensions 76" wide x 48" Front to Back x 53" tall - Entrance table sits at 40

This hydraulic sheet metal brake allows the operator to dial in a programmed bend when the machine is used in the manual or semi-automatic mode

Roll Adjustment Manual Pipe Capacity Size: 1

the operator may chose to use the manual hand pump that is located on the side of the HSP-75A pneumatic press

92 gal Working Speed

The large 6” belt width allows it to notch up to 3” OD tubing at 60 degrees with optional mandrels

New Tin Knocker 10' X 16 Gauge Straight Brake

Spindle Travel 5

To find out more information about our variable speed drill presses

so you can run it through the workpiece

the SW-22M-P manual ironworker from Baileigh Industrial allows the operator to punch